Honda HR-V: Transmission
Honda HR-V (2015-2021) Service Manual / Transmission
- Continuously Variable Transmission (CVT) - Service Information
- CVT Differential Carrier Bearing Outer Race Replacement (CVT)
- CVT Differential Oil Seal Replacement (CVT)
- CVT Driven Pulley Pressure Sensor Removal and Installation (CVT)
- CVT Transmission Removal and Installation (CVT)
- CVTF Warmer Removal and Installation (CVT)
- Final Drive Shaft Tapered Roller Bearing Outer Race Replacement (CVT)
- Paddle Shifter Removal and Installation (CVT)
- Shift Cable Removal and Installation (CVT)
- Shift Lever Removal and Installation (CVT)
- Solenoid Wire Harness Removal and Installation (CVT)
- Torque Converter Housing Bearing Replacement (CVT)
- Transfer Assembly Removal and Installation (CVT)
- Transmission Fluid (HCF-2) Replacement (CVT)
- Transmission Fluid Pan Removal and Installation (CVT)
- Transmission Fluid Pump Removal and Installation (CVT)
- Transmission Housing Control Shaft Oil Seal Replacement (CVT)
- Transmission Housing Secondary Drive Gear Removal and Installation (CVT)
- Transmission Housing Transmission Fluid Pump Drive Sprocket Bearing Replacement (CVT)
- Transmission Range Switch Removal and Installation (CVT)
- Valve Body Assembly Removal and Installation (CVT)
- Continuously Variable Transmission (CVT) - Testing & Troubleshooting
- Inspection & Adjustment
- Description
- DTC Troubleshooting Index
- Testing
- Check
- Symptom Troubleshooting
- Troubleshooting
- Disassembly and Reassembly
- Component Location Index
- How to Information
- Manual Transaxle - Service Information
- Manual Transaxle - Testing & Troubleshooting
READ NEXT:
CVT Differential Carrier Bearing Outer Race Replacement (CVT)
Special Tools Required
Bearing Driver Attachment, 62 x 68 mm
07746-0010500
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 62 x 64 mm
07947-6340400
Replacement
NOTE:
The c
CVT Differential Oil Seal Replacement (CVT)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver, 65 mm 07JAD-PL90100
Oil Seal Driver Attachment, 58 mm
07JAD-PH80101
Replacement
NOTE: Apply a light coat of clean tran
SEE MORE:
Inspection & Adjustment
DRIVE BELT AUTO-TENSIONER INSPECTION
Inspection
1. Drive Belt Auto-Tensioner - Position Check
Turn the vehicle to the ON mode, and make sure to turn the A/C switch
OFF, then turn
the vehicle to the OFF (LOCK) mode.
Check the position of the drive belt auto-tensioner indicator pointer
(A) an
Inspection/Adjustment
MOONROOF GLASS POSITION ADJUSTMENT
Adjustment
1. Moonroof Glass Position - Check
The roof panel (A) should be even with the glass roof seal (B) to within
0-1/-1
mm (0-0.04/-0.04 in) all the way around. If not, make the following
adjustment:
2. Moonroof Glass Position - Adjust
Slightly lo
© 2019-2025 Copyright www.hohrv2.com
