Honda HR-V: Lubrication System - Service Information
READ NEXT:
Removal
1. Oil Filter - Remove
2. Oil Filter Feed Pipe - Remove
Installation
1. Oil Filter Feed Pipe - Install
Install the two 20 x 1.5 mm nuts (A) onto the oil filter feed pipe. Hold
one nut wit
Removal
1. Oil Pressure Switch - Remove
Disconnect the connector (A)
Remove the oil pressure switch
Remove any old liquid gasket from the oil pressure switch and the oil
pressure switch mounting
SEE MORE:
NOTE:
Before you troubleshoot, review the general troubleshooting information.
Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on the
instructions in the table below.
The DTC may be stored due to loss of voltage supply or ground at the
transmi
Inspection
Transfer Gear Backlash Measurement
1. Vehicle - Lift
2. Propeller Shaft (Transfer Side) - Disconnect
3. Transfer Assembly - Transfer Gear Backlash Check
Shift the transmission to N
Set a dial indicator (A) on the transfer companion flange (B).NOTE: Position the dial indicator tip (C)