Honda HR-V: Starting System - Testing & Troubleshooting
Honda HR-V (2015-2021) Service Manual / Engine / Starting System - Testing & Troubleshooting
READ NEXT:
Testing, Symptom Troubleshooting
TESTING
ENGINE START/STOP SWITCH TEST
Test
1. Dashboard switch Panel - Remove
2. Engine Start/Stop Switch - Test
Check the engine start/stop switch (A) according to the table.
NOTE:
When an
Starter System Circuit Troubleshooting (With Keyless Access System)
NOTE:
Air temperature must be between 59-100ºF (15-38ºC) during this
procedure.
After the inspection, you must reset the PCM. Otherwise, the PCM will
continue to stop the fuel
injectors
SEE MORE:
DTC B1002 MICU Internal Error (EEPROM Error)
DTC (MICU)
NOTE : If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Test Mode
A - Initial Communication and DTC Checks.
1. Problem verification:
The DTCs with th
DTC B12D0, B12D1, B12D2
NOTE: Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Power Control Unit)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Test Mode A - Ref
© 2019-2026 Copyright www.hohrv2.com
