Honda HR-V Owners & Service Manuals

Honda HR-V: Testing

READ NEXT:

 CKP Pattern Clear/CKP Pattern Learn Procedure

Procedure NOTE: Clearing the DTCs with the HDS does not require you to do this procedure. The PCM memorizes the learning status in its memory after passed an hour from turning the vehicle to t

 PCM Idle Learn Procedure

Procedure The idle learn procedure must be done so the PCM can learn the engine idle characteristics. Do the idle learn procedure whenever you do any of these actions: Replace the PCM. Reset the

 Throttle Body Cleaning

Cleaning Do not insert your fingers into the installed throttle body when you turn the vehicle to the ON mode, or while the vehicle is in ON mode. If you do, you will seriously injure your fingers i

SEE MORE:

 DTC Troubleshooting 108-11: Steering Angle Sensor Stuck

NOTE: Before you troubleshoot, review the general troubleshooting information. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTCs with the HDS. Turn the vehicle to the OFF (LOCK) mode. Test-drive the vehicle. NOTE: Drive the vehicle on the road, not on a lift. Check fo

 F-CAN Circuit Troubleshooting

1. F-CAN circuit resistance check: Turn the vehicle to the OFF (LOCK) mode. Jump the SCS line with the HDS. SCS Short Disconnect the following connector. PCM connector A (51P) Measure the resistance between test points 1 and 2. Is there about 78-95 -- YES Go to step 14. NO Go to step 2.

© 2019-2026 Copyright www.hohrv2.com