Honda HR-V: Testing
- ECON Switch Test
- Outside Air Temperature Indicator Calibration
- Reminder Systems (MICU And Gauge Control Module) Input Test
- Rewriting The ODO Data And Transferring The Service Reminder System Data To A New Gauge Control Module
- Safety Indicator System (MICU And Gauge Control Module) Input Test
READ NEXT:
ECON Switch Test
Test
1. Driver's Dashboard Lower Cover - Remove
2. ECON Switch - Test
Check the ECON switch (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED
illumina
Outside Air Temperature Indicator Calibration
Procedure
NOTE: To test the outside air temperature sensor, refer to the outside air
temperature sensor test procedure
1. Outside Air Temperature Indicator - Calibrate
Description
The outside air tem
Reminder Systems (MICU And Gauge Control Module) Input Test
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Tes
SEE MORE:
A/F Sensor Removal and Installation
Special Tools Required
O2 Sensor
Wrench Snap-on
S6176 or
equivalent,
commercially
available
Removal & Installation
1. A/F Sensor - Remove
Fig. 1: A/F Sensor With Torque Specification
Disconnect the connector (A)
Remove the A/F sensor (B).
2. All Removed Parts - Install
Install the parts
Unit Check (Quick Check) - Audio System Diagnostic Mode
These screens allow you to diagnose the audio unit and related units. Some of
the tests and screens that are displayed under the Unit Check are same as the
checks listed under the
Detail Information & Setting.
To start the test, select the item you want to check.
NOTE: These items describe in
© 2019-2026 Copyright www.hohrv2.com
