Honda HR-V: Testing
- Heated Windshield Wiper Area Switch Test
- Tailgate Latch Switch Test
- Washer Motor Test
- Wipers/Washers (MICU) Input Test
READ NEXT:
Heated Windshield Wiper Area Switch Test
Test
1. Driver's Dashboard Lower Cover - Remove
2. Heated Windshield Wiper Area Switch - Test
NOTE : Mounting position of the heated windshield wiper area switch (A) is
changed depending on the
model
Tailgate Latch Switch Test
Test
1. Tailgate Lower Trim Panel - Remove - Refer to: Interior Trim Removal and
Installation - Door Areas,
or Interior Trim Removal and Installation - Tailgate Areas, or Interior Trim
Removal and
I
Washer Motor Test
Test
1. Right Front Inner Fender - Remove
Remove the right front inner fender as needed - Refer to: Front Inner
Fender Removal and
Installation, or Rear Inner Fender Removal and Installation.
2.
SEE MORE:
CVT Differential Oil Seal Replacement (CVT)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver, 65 mm 07JAD-PL90100
Oil Seal Driver Attachment, 58 mm
07JAD-PH80101
Replacement
NOTE: Apply a light coat of clean transmission fluid on all parts before
installation.
Transmission Housing Side
1. Differential Oil Seal
Side Turn Signal Light Removal and Installation
Removal
1. Power Mirror - Remove
2. Mirror Holder - Remove
3. Mirror Housing Cover - Remove
4. Side Turn Signal Light - Remove
Remove the cover (A).
Remove the bracket (A).
Remove the mirror housing under cover (A).
Disconnect the connector (A)
Remove the side turn signal light (B).
© 2019-2025 Copyright www.hohrv2.com
