Honda HR-V: Troubleshooting
READ NEXT:
Keyless Access System Touch Sensor Circuit Troubleshooting
Testing
1. Keyless access system check 1:
Select KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select
menu with
the HDS, and enter HISTORY DATA.
One-Push - KEYLESS ACCESS CONTROL UN
Keyless Buzzer Circuit Troubleshooting
Testing
1. Open wire check (GND line):
Turn the vehicle to the OFF (LOCK) mode.
Disconnect the following connector.
Keyless buzzer 3P connector
Check for continuity between test points 1 and 2.
SEE MORE:
DTC B0029-13
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
Engine Stalls
Special Tools Required
Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially
available
NOTE:
Before beginning this troubleshooting, do a customer diagnostic
interview - Refer to: Fuel and
Emissions Systems Symptom Troubleshooting - Engine stalls Diagnostic
interview, or Fu
© 2019-2026 Copyright www.hohrv2.com
