Honda HR-V: Disassembly and Reassembly
Honda HR-V (2015-2021) Service Manual / Transmission / Manual Transaxle - Testing & Troubleshooting / Disassembly and Reassembly
- Manual Transmission Disassembly and Reassembly (M/T)
- Reverse Idler Gear Shaft Assembly Disassembly and Reassembly (M/T)
READ NEXT:
Manual Transmission Disassembly and Reassembly (M/T)
Special Tools Required
Snap Ring Pliers 07LGC-0010100
Exploded View
1. Clutch Housing - Exploded View
Fig. 5: Exploded View Of Clutch Housing With Torque Specifications
2. Transmission Housing - Exp
Reverse Idler Gear Shaft Assembly Disassembly and Reassembly (M/T)
Exploded View
NOTE: Prior to reassembling, clean all parts in solvent, dry them, and apply
MTF to all contact surfaces.
1. Reverse Idler Gear Shaft Assembly - Exploded View
Fig. 18: Exploded View Of
Inspection and Replacement
MTF INSPECTION AND REPLACEMENT (M/T)
Inspection
1. Vehicle - Lift
2. Engine Undercover - Remove
3. MTF - Check
Remove the oil check bolt (A) and the 6 mm sealing washer (B)
Check the condition of
SEE MORE:
Shift Cable Adjustment (CVT)
Adjustment
1. Shift Lever Knob / Shift Lever Boots - Remove
NOTE: Do not wipe off the special grease applied to the area of the shift
lever marked with an asterisk (*).
2. Center Console - Remove
3. Shift Cable (Shift Lever Side) - Remove
Shift the transmission to R position/mode.NOTE: Do not w
DTC Troubleshooting B0082-12: Short to Power in the Selectable
Energy Absorption Device of the Front Passenger's Seat Belt Tensioner
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
© 2019-2026 Copyright www.hohrv2.com
