Honda HR-V: Manual Transaxle - Testing & Troubleshooting
READ NEXT:
Adjustment
NOTE:
For a clutch interlock operation problem, check clutch pedal position
switch A.
If there is no clearance between the master cylinder piston and the push
rod, the release bearin
Inspection
NOTE: Before inspection, make sure the special bolt is tightened to the
specified torque.
1. Countershaft Assembly Clearance - Inspect
Measure the clearance between 1st gear (A) and the
SEE MORE:
Removal & Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC) and the precautions and procedures before doing
repairs or service.
1. 12 Volt Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes b
1. Select HOME.
2. Select Settings.
3. Select Audio.
4. Select Sound.
Select the tabs to adjust the following choices:
BASS, TREBLE, FADER, BALANCE, SVC
(Speed-sensitive Volume Compensation)
The SVC has four modes: Off, Low, Mid, and High.
SVC adjusts the volume level based on the vehicle
spee