Honda HR-V Owners & Service Manuals

Honda HR-V: Keyless Access System Symptom Troubleshooting - Keyless Access Indicator Does Not Go OFF Or Does Not Come ON

Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Security System Keyless Entry System - Testing & Troubleshooting / Symptom Troubleshooting / Keyless Access System Symptom Troubleshooting - Keyless Access Indicator Does Not Go OFF Or Does Not Come ON

1. Keyless access system check.

  1. Turn the vehicle to the OFF (LOCK) mode.
  2. Turn the vehicle to the ON mode.
  3. Check the keyless access indicator.

Does the keyless access indicator come on for 2 seconds?

YES

Go to step 2.

NO

Do the gauge control module self-diagnostic function. If the indicator does not come on, replace the gauge control module.

2. Keyless access system check.

  1. Check the keyless access indicator.

Does the indicator blink once, then stay off?

YES

Intermittent failure, the system is OK at this time.

NO

Go to step 3.

3. POWER CONTROL UNIT, BACKUP CONTROL UNIT, and KEYLESS ACCESS CONTROL UNIT DTCs check:

  1. Connect the HDS to the data link connector (DLC).
  2. Check for DTCs in the POWER CONTROL UNIT, BACKUP CONTROL UNIT, and KEYLESS ACCESS CONTROL UNIT with the HDS.

POWER CONTROL UNIT

Security System Keyless Entry System - Testing & Troubleshooting

DTC (POWER CONTROL UNIT)

BACKUP CONTROL UNIT

Security System Keyless Entry System - Testing & Troubleshooting

DTC (BACKUP CONTROL UNIT)

KEYLESS ACCESS CONTROL UNIT

Security System Keyless Entry System - Testing & Troubleshooting

DTC (KEYLESS ACCESS CONTROL UNIT)

Are there any DTCs?

YES

Go to the indicated DTC troubleshooting.

NO

Replace the gauge control module.

    READ NEXT:

     Keyless Access System Symptom Troubleshooting - The Doors Will Not Unlock Or Lock With The Door Outer Handle Touch Sensor Or Lock Switch, But Will Unlock Or Lock With The Keyless Remote

    1. Keyless access system check. Turn the vehicle to the ON mode. Does the system change to ON mode? YES Go to step 2. NO Go to the keyless access system symptom troubleshooting "Cannot select ON m

     Keyless Access System Symptom Troubleshooting - The Doors Will Not Unlock Or Lock With The Keyless Remote, But Will Unlock Or Lock With The Door Outer Handles

    1. Door lock actuator operation check 1. Remove all the keyless remotes from inside the vehicle, and close all doors and the tailgate. Push each LOCK and UNLOCK buttons of the keyless remote, at

     Keyless Access System Symptom Troubleshooting - The Engine Starts But Stalls Immediately

    1. Keyless access system check 1. Turn the vehicle to the ON mode. Check the immobilizer indicator. Is the immobilizer indicator come on? YES Go to step 2. NO Go to step 6. 2. Keyless access syste

    SEE MORE:

     USB Device Does Not Function (Without Navigation, Display Audio Type (7-inch Screen) )

    NOTE: Check the vehicle 12 volt battery condition first. Check the USB's specifications: Mass-storage class ready digital audio player with USB 2.0 port More than 256 MB storage space Supports MP3, WMA, and AAC (encoded with the iTunes) files, DRM files are not supported Not all pla

     Adjusting the Sound

    Press the (sound) button, and rotate to scroll through the following choices: Rotate to adjust the sound setting, then press . The SVC has four modes: Off, Low, Mid, and High. SVC adjusts the volume level based on the vehicle speed. As you go faster, audio volume increases. As you slow down

    © 2019-2024 Copyright www.hohrv2.com