Honda HR-V: Pistons, Connecting Rods & Bearings
Honda HR-V (2015-2021) Service Manual / General Information / Engine Overhaul Procedures / Pistons, Connecting Rods & Bearings
READ NEXT:
Ridge Removal
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
Assembling Piston & Connecting Rod
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
Main & Connecting Rod Bearing Clearance
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
SEE MORE:
Testing
FRONT SEAT HEATER CONTROL UNIT INPUT TEST
NOTE : Before testing, make sure the No. C19 (20 A), No. C24 (7.5 A), and No.
C39 (10 A) fuses in the under-dash
fuse/relay box are OK.
1. Disconnect the front seat heater control unit 14P connector.
2. Inspect the connector and socket terminals to be sure
Transmission Housing Control Shaft Oil Seal Replacement (CVT)
Special Tools Required
Attachment, 22 x 24 mm
07746-001A800
Driver Handle, 15 x 135L 07749-0010000
Replacement
NOTE: Apply a light coat of clean transmission fluid on all parts before
installation.
1. Control Shaft Oil Seal - Remove
2. Control Shaft Oil Seal - Install
Install the oil seal (A)
© 2019-2026 Copyright www.hohrv2.com
