Honda HR-V Owners & Service Manuals

Honda HR-V: Removal Installation

READ NEXT:

 AWD Control Unit Removal and Installation (AWD)

Removal 1. Rear Left Side Trim Panel - Remove - Refer to: Interior Trim Removal and Installation - Rear Side Area, or 2. AWD Control Unit - Remove Turn the vehicle to the OFF (LOCK) mode Loosen t

 Rear Differential Breather Box and Hose Removal and Installation (AWD)

Removal & Installation 1. Vehicle - Lift 2. Rear Differential Breather Box and Hose - Remove Rear differential pump motor Rear differential Disconnect the breather hoses (A). Remove the b

 Rear Differential Mount Removal and Installation (AWD)

Removal 1. Vehicle - Lift 2. No. 2 Propeller Shaft - Disconnect 3. Rear Differential - Support 4. Rear Differential Front Mount - Remove Remove the rear differential front mount bracket (A). R

SEE MORE:

 DTC Troubleshooting 98-11: Seat Belt Buckle Switch Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information. VSA will set this DTC if any SRS DTCs exist. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTC with the HDS. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode. Check for DTCs wit

 Side Impact Sensor (Second) Removal and Installation

Removal and Installation SRS components are located in this area. Review the SRS component locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the precautions and procedures before doing repairs or service. 1. 12 Volt Battery Terminal - Disconnec

© 2019-2026 Copyright www.hohrv2.com