Honda HR-V: Fuel and Emissions - Service Information
READ NEXT:
Removal and Installation
1. Fuel Pressure - Relieve
2. Fuel Tank - Drain
3. Fuel Cap Adapter - Remove
4. Rear Axle Beam - Remove - Refer to: Rear Axle Beam Removal and
Installation (2WD), or Rear Axl
Removal and Installation
1. Fuel Pressure - Relieve
2. Fuel Tank - Drain
3. Fuel Cap Adapter - Remove
4. Front Floor Undercover - Remove - Refer to: Rear Floor Undercover Removal
and Installation
(2W
Removal
NOTE: Before you work on the fuel lines and fittings, read
the Fuel Line/Quick-Connect Fitting Precautions.
1. Fuel Line/Quick-Connect Fitting - Remove
If equipped, remove the quick-connec
SEE MORE:
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Driver, 30 mm I.D. 07946-MB00000
Disassembly
NOTE: Refer to the Exploded View as needed during this procedure.
1. Mainshaft - Disassemble
Support 6th gear (A) on steel blocks, and press the mainshaft out of the
angular ball
beari
FRONT SEAT HEATER CONTROL UNIT INPUT TEST
NOTE : Before testing, make sure the No. C19 (20 A), No. C24 (7.5 A), and No.
C39 (10 A) fuses in the under-dash
fuse/relay box are OK.
1. Disconnect the front seat heater control unit 14P connector.
2. Inspect the connector and socket terminals to be sure