Honda HR-V: Reminder Indicator (Reset Procedures)
READ NEXT:
NOTE: To determine the appropriate reset procedure, refer to EMISSIONS
MAINTENANCE REMINDER RESET INDEX.
EMISSIONS MAINTENANCE REMINDER RESET INDEX
EMISSIONS MAINTENANCE REMINDER RESET - PROCEDURE 1
NOTE: To determine the appropriate reset procedure, refer to ENGINE OIL
REPLACEMENT REMINDER RESET INDEX.
ENGINE OIL REPLACEMENT REMINDER RESET INDEX
(1) Beginning with 2012 models, Honda no longer
ENGINE OIL REPLACEMENT REMINDER RESET - PROCEDURE 1
NOTE: For Civic and CR-V, this procedure is for models with the
Information Display.
For 2013-15 Civic and CR-V models with i-MID, see PROCEDURE 1
SEE MORE:
Removal and Installation
Front
1. Vehicle - Lift
2. Front Wheels - Remove
3. Front Wheel Speed Sensor - Remove
Remove the grommet (A) from the body.
Disconnect the connector (B)
Remove the wire guide rubbers (C), the clip (D), and the bolt (E)
Remove the wheel speed sensor (F).
4. All Removed
Special Tools Required
Driver Handle, 40 mm I.D.
07746-0030100
Replacement
Driveshaft Side
1. Vehicle - Lift
2. Rear Differential Assembly - Remove
3. Oil Seal - Remove
4. Oil Seal - Install
Install a new oil seal (A) even and flush with the machined edge of the
differential carrier assembly