Honda HR-V: Symptom Troubleshooting
Honda HR-V (2015-2021) Service Manual / Restraints / Supplemental Restraint System - Testing & Troubleshooting / Symptom Troubleshooting
- SRS Symptom Troubleshooting - Front Passenger's Airbag ON Indicator Does Not Go OFF
- SRS Symptom Troubleshooting - Front Passenger's Airbag ON/OFF Switch to OFF, But Front Passenger's Airbag OFF Indicator Does Not Come ON
- SRS Symptom Troubleshooting - Front Passenger's Airbag ON/OFF Switch To ON, But Front Passenger's Airbag ON Indicator Does Not Come ON
- SRS Symptom Troubleshooting - Front Passenger's Airbag Cutoff Indicator Stays ON Or Comes ON Suddenly
- SRS Symptom Troubleshooting - Front Seat Belt Reminder Indicator Does Not Come ON, Turn OFF, Or Flash (KA/KC)
- SRS Symptom Troubleshooting - SRS Indicator Stays ON, But No DTCS Are Stored, Or Cannot Be Read
READ NEXT:
SRS Symptom Troubleshooting - Front Passenger's Airbag ON Indicator
Does Not Go OFF
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new components of the correct par
SRS Symptom Troubleshooting - Front Passenger's Airbag ON/OFF Switch
to OFF, But Front Passenger's Airbag OFF Indicator Does Not Come ON
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new components of the correct par
SRS Symptom Troubleshooting - Front Passenger's Airbag ON/OFF Switch
To ON, But Front Passenger's Airbag ON Indicator Does Not Come ON
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new components of the correct par
SEE MORE:
Manual Transaxle - Service Information
Back-Up Light Switch Removal and Installation (M/T)
Removal
1. Air Cleaner - Remove
2. Back-Up Light Switch - Removal
Disconnect the connector (A)
Remove the back-up light switch (B).
Installation
1. Back-Up Light Switch - Install
Fig. 1: Back-Up Light Switch With Torque Specifications
Clean
DTC Troubleshooting B0097-87: No Signal From the Right Side Impact
Sensor (Second)
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
© 2019-2026 Copyright www.hohrv2.com
