Honda HR-V: Testing
READ NEXT:
1. Turn the vehicle to the OFF (LOCK) mode
2. Disconnect the automatic dimming inside mirror 7P connector.
3. Check for continuity between terminal No. 6 and body ground.
If there is continuity, go
Test
1. Front Door Panel - Remove
2. Power Mirror Actuator - Test
Without side turn signal light
With side turn signal light
Disconnect the connector
(A).
Actuator Test
Check the actuator ope
1. Disconnect the following connector.
Power mirror switch 13P connector
2. Choose the appropriate test based on the symptom:
Both mirrors do not work, go to step 3.
Left mirror does not work, go
SEE MORE:
Special Tools Required
Driver Handle, 40 mm I.D.
07746-0030100
Replacement
Driveshaft Side
1. Vehicle - Lift
2. Rear Differential Assembly - Remove
3. Oil Seal - Remove
4. Oil Seal - Install
Install a new oil seal (A) even and flush with the machined edge of the
differential carrier assembly
How to Check for DTCs With the HDS
NOTE:
There are three methods used to check for DTCs. The recommended method
is to use the Honda
Diagnostic System (HDS) with the appropriate software, plugged into the data
link connector (DLC).
The second method is to run the self-diagnostic function buil