Honda HR-V: Steering System - Service Information
READ NEXT:
Special Tools Required
Ball Joint Thread
Protector, 12 mm
07AAFSDAA100
Ball Joint Thread
Protector, 14 mm
071AF-SZNA100
Ball Joint
Remover, 32 mm
07MAC-SL00102
Ball Joint
Remover, 28 mm
07MAC-SL002
Removal & Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC) and the precautions and procedures before
Removal & Installation
1. Vehicle - Lift
2. Fuel Tank Gard Pipe - Remove
3. Front center member - Remove
4. Propeller Shaft - Remove
Remove the propeller shaft protector (A).
Make a refere
SEE MORE:
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine overhaul process. Descriptions of processes
of cleaning, inspection, assembly and machine shop pract
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
Check for DTCs with the HDS.
Is DTC 11-12, 13-12, 15-12, or 17-