Honda HR-V Owners & Service Manuals

Honda HR-V: Steering

READ NEXT:

 Steering System - Service Information

 Ball Joint Removal

Special Tools Required Ball Joint Thread Protector, 12 mm 07AAFSDAA100 Ball Joint Thread Protector, 14 mm 071AF-SZNA100 Ball Joint Remover, 32 mm 07MAC-SL00102 Ball Joint Remover, 28 mm 07MAC-SL002

 Dashboard/Steering Hanger Beam Removal and Installation

Removal & Installation NOTE: SRS components are located in this area. Review the SRS component locations - Refer to: SRS Component Location Index (KA/KC) and the precautions and procedures before

SEE MORE:

 DTC Troubleshooting 27-12, 27-13: Steering Angle Sensor Stuck, Output Signal Malfunction

NOTE: This DTC may set if the vehicle is driven on a lift (wheels are turning) and the steering wheel is turned significantly. This is normal, ignore it. Before you troubleshoot, review the general troubleshooting information. 1. Steering angle sensor performance check 1: Slowly drive the

 Center Console Armrest Removal and Installation

Removal & Installation 1. Center Console Rear Trim - Remove 2. Center Console Armrest - Remove Remove the screw, then remove the hinge pin (A) Remove the center console armrest (B). 3. All Removed Parts -Install Install the parts in the reverse order of removal. CENTER CONSOLE PAD REMOVA

© 2019-2026 Copyright www.hohrv2.com