Honda HR-V: Audio Visual Systems - Service Information
READ NEXT:
Removal & Installation
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and th
Removal & Installation
NOTE:
When working on electronic components, make sure the work area is clean
and dust free.
Make sure your hands are clean and free of oils and grease.
Eject the CD b
Removal & Installation
NOTE:
When working on electronic components, make sure the work area is clean
and dust free.
Make sure your hands are clean and free of oils and grease.
Eject the CD b
SEE MORE:
INSPECTION & ADJUSTMENT
CYLINDER HEAD INSPECTION FOR WARPAGE
Inspection
1. Cylinder Head - Remove
2. Cylinder Head Warpage - Inspect
Check the cylinder head for warpage. Measure along
the edges, and three ways across the center:
If warpage is less than 0.08 mm (0.0031 in)
cylinder head
Removal & Installation
1. Front Bumper - Remove
2. Outside Air Temperature Sensor - Remove
Disconnect the connector (A)
Lift the tab (B) to release the lock, then remove the outside air
temperature sensor (C).
3. All Removed Parts - Install
Install the parts in the reverse order of remov