Honda HR-V: Disassembly and Reassembly
READ NEXT:
Special Tools Required
Installer Attachment 40 mm 07LAD-PW50601
Exploded View
1. Differential - Exploded View
Fig. 32: Exploded View Of Differential
Disassembly
NOTE: The carrier bearing and the car
Special Tools Required
Reverse Brake Spring Compressor Set 070AF-5T00100
Snap Ring Pliers 07LGC-0010100
Clutch Compressor Attachment 07ZAE-PRP0100
Clutch Compressor Attachment 64 mm 07ZAE-PRP0110
NOTE:
Refer to the Exploded View as needed during this procedure.
Keep all foreign particles out of the transmission.
1. Transfer Assembly - Remove (With AWD)
Remove the transfer (A) with the O
SEE MORE:
Continuously variable transmission models
Follow the procedure below if you cannot move the shift lever out of the (P
position.
â– Releasing the Lock
1. Set the parking brake.
Models without smart entry system
2. Remove the key from the ignition switch.
Models with smart entry system
2. Remove the b
1. PCU DTC check.
Turn the vehicle to the ON mode.
Connect the HDS to the data link connector (DLC).
Check for DTCs in the POWER CONTROL UNIT with the HDS.
DTC (POWER CONTROL UNIT)
Are there any DTCs?
YES
Go to indicated DTC troubleshooting.
NO
Go to step 2.
2. Shorted wire check (KEY SW line)