Honda HR-V: Multiplex Integrated Control Unit (Micu) - Diagnostics
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Multiplex Integrated Control Unit (Micu) - Diagnostics
- DTC B1002 MICU Internal Error (EEPROM Error)
- DTC B1028: Rear Wiper Motor (Park) Signal Error
- DTC B1077 Windshield Wiper Motor (Park) Signal Error
- DTC B1127 Driver's Door Key Cylinder Switch Input Circuit Malfunction (Simultaneous Input of Lock and Unlock Signal)
- DTC B1128 Driver's Door Remote Switch Input Circuit Malfunction (Simultaneous Input of Lock and Unlock Signal)
- DTC B1129 Driver's Door Knob Switch Input Circuit Malfunction (Simultaneous Input of Lock and Unlock Signal)
- DTC B1275, B1276, B1277, B1278 : Headlight Malfunctions
- DTC B1279 Dimmer Switch Circuit Malfunction
- DTC B1280 Turn Signal Switch Circuit Malfunction
- DTC B1281, B1282, B1283, B1284 Front Wiper Position Circuit Malfunctions
- DTC U1280 (MICU) B-CAN Communication Bus Line Error (BUS-OFF)
- DTC U128D (MICU) MICU Lost Communication With Gauge Control Module
READ NEXT:
DTC B1002 MICU Internal Error (EEPROM Error)
DTC (MICU)
NOTE : If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagn
DTC B1028: Rear Wiper Motor (Park) Signal Error
DTC (MICU)
NOTE : If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagn
DTC B1077 Windshield Wiper Motor (Park) Signal Error
DTC (MICU)
NOTE : If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagn
SEE MORE:
DTC Troubleshooting 98-11: Seat Belt Buckle Switch Malfunction
NOTE:
Before you troubleshoot, review the general troubleshooting information.
VSA will set this DTC if any SRS DTCs exist.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
Check for DTCs wit
Keyless Access System Symptom Troubleshooting - All The Doors And The
Tailgate Will Not Lock And Unlock
1. Door lock actuator operation check 1:
Remove all the keyless remotes from inside the vehicle, and close all
doors and the tailgate.
Push each LOCK and UNLOCK buttons of the keyless remote, at least 10
times.
Do the door lock actuators work normally?
YES
Go to step 2.
NO
Go to step 3.
2. D
© 2019-2026 Copyright www.hohrv2.com
