Honda HR-V Owners & Service Manuals

Honda HR-V: Doors - Service Information

READ NEXT:

 Door Subseal Removal and Installation

Removal & Installation Front Door Subseal 1. Front Door Subseal - Remove Remove the front door subseal (A). 2. All Removed Parts - Install Install the parts in the reverse order of removal.

 Front Door Channel Tape Replacement

Replacement NOTE : Keep dust away from the working area. When working at lower temperatures, heat the door channel and door channel tape with a hair dryer. Door channel: about 59 ºF (15 º

 Front Door Checker Removal and Installation

Removal & Installation 1. Front Door Panel - Remove 2. Front Door Plastic Cover - Remove Remove the plug cap (A) Disconnect the connector (B) Remove the harness clips (C) Remove the front do

SEE MORE:

 DTC B0001-13 (KA/KC)

Special Tools Required SRS Inflator Simulator 07SAZ-TB4011A SRS Simulator Lead J 070AZ-SNAA100 NOTE: Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part

 Side Impact Sensor (Second) Removal and Installation

Removal and Installation SRS components are located in this area. Review the SRS component locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the precautions and procedures before doing repairs or service. 1. 12 Volt Battery Terminal - Disconnec

© 2019-2026 Copyright www.hohrv2.com