Honda HR-V: Suspension System - Service Information
Honda HR-V (2015-2021) Service Manual / Suspension System / Suspension System - Service Information
- Front Damper/Spring Removal and Installation
- Front Knuckle/Hub/Wheel Bearing Replacement
- Front Lower Arm Ball Joint Removal and Installation
- Front Lower Arm Removal and Installation
- Front Stabilizer Bar Removal and Installation (2WD)
- Front Stabilizer Bar Removal and Installation (AWD)
- Front Stabilizer Link Removal and Installation
- Rear Axle Beam Removal and Installation (2WD)
- Rear Axle Beam Removal and Installation (AWD)
- Rear Damper Removal, Installation, and Inspection
- Rear Hub Bearing Unit Removal and Installation (2WD)
- Rear Hub Bearing Unit Removal and Installation (AWD)
- Rear Spring Removal and Installation (AWD)
- Rear Stabilizer Bushing Removal and Installation
- Wheel Bolt Removal and Installation
READ NEXT:
Front Damper/Spring Removal and Installation
Removal & Installation
1. Vehicle - Lift
2. Front Wheel - Remove
3. Stabilizer Link - Disconnect
Disconnect the stabilizer link from the damper.
4. Damper/Spring Items - Remove
Fig. 1: Brake H
Front Knuckle/Hub/Wheel Bearing Replacement
Special Tools Required
Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
Ball Joint Thread Protector, 14 mm 071AF-SZNA100
Ball Joint Remover, 32 mm 07MAC-SL00102
Ball Joint Remover, 28 mm 07MAC-SL00
Front Lower Arm Ball Joint Removal and Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-SZNA100
Ball Joint Remover, 32 mm 07MAC-SL00102
Removal & Installation
1. Vehicle - Lift
2. Front Wheel - Remove
3. Lower Arm Ball
SEE MORE:
Transmission Housing Transmission Fluid Pump Drive Sprocket Bearing
Replacement (CVT)
Special Tools Required
Snap Ring Pliers 07LGC-0010100
Bearing Driver Attachment, 52 x 55 mm
07746-0010400
Driver Handle, 15 x 135L 07749-0010000
Replacement
NOTE: Apply a light coat of clean transmission fluid on all parts before
installation.
1. Transmission Fluid Pump Drive Sprocket Bearing -
DTC B12D0, B12D1, B12D2
NOTE: Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Power Control Unit)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Test Mode A - Ref
© 2019-2026 Copyright www.hohrv2.com
