Honda HR-V: Exterior Trim - Service Information
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Exterior Trim - Service Information
- Cowl Cover Removal and Installation
- Emblem/Sticker Removal and Installation
- Engine Undercover Removal and Installation
- Front Bumper Air Spoiler Removal and Installation
- Front Fender Fairing Removal and Installation
- Front Fog Light Trim Removal and Installation
- Front Grille Stay Removal and Installation
- Fuel Cap Adapter Removal and Installation
- Fuel Fill Door Opener Removal and Installation
- Hood Insulator Removal and Installation
- Horn Removal, Installation, and Test
- Rear Bumper Reflector Removal and Installation
- Rear Inner Fender Removal and Installation
- Roof Molding Removal and Installation
- Side Sill Panel Removal and Installation
- Tailgate Dynamic Damper Removal and Installation
- Tailgate Outer Handle Switch Removal, Installation, and Test
- Tailgate Spoiler Trim Removal and Installation
- Washer Fluid Level Switch Removal, Installation, and Test
- Washer Tube Removal and Installation
- Wiper Arm Removal and Installation
- Wiper Motor Removal and Installation
- Wiper/Washer Switch Removal, Installation, and Test
READ NEXT:
Cowl Cover Removal and Installation
Removal & Installation
Cowl Cover
1. Windshield Wiper Arms - Remove
2. Front Fender Cover - Remove
Remove the front fender cover (A). (both sides)
3. Cowl Cover - Remove
Remove the hood rea
Emblem/Sticker Removal and Installation
Removal
Front Emblem
1. Front Grille - Remove
2. Front Emblem - Remove
Rear Center Emblem
3. Rear License Trim - Remove
4. Rear Center Emblem - Remove
Rear Emblem
5. Rear Emblem - Remove
Installation
Engine Undercover Removal and Installation
Removal & Installation
1. Vehicle - Lift
2. Engine Undercover - Remove (For Some Models)
Remove the engine undercover (A).
3. Front Splash Shield - Remove
Remove the front splash shield (A)
SEE MORE:
DTC B0070-11
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
DTC B0010-11, B0011-11
Special Tools Required
SRS Inflator Simulator 07SAZ-TB4011A
SRS Simulator Lead J 070AZ-SNAA100
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct par
© 2019-2026 Copyright www.hohrv2.com
