Honda HR-V: Engine Control System & Engine Mechanical - Service Information
Honda HR-V (2015-2021) Service Manual / Engine / Engine Control System & Engine Mechanical - Service Information
- A/F Sensor Removal and Installation
- Air Cleaner Element Removal, Installation, and Inspection
- CKP Sensor Removal and Installation
- Camshaft Removal and Installation
- Connecting Rod Bearing Replacement
- Crankshaft Main Bearing Replacement
- Crankshaft Pulley Removal and Installation
- Crankshaft and CKP Pulse Plate Removal, Installation, and Inspection
- Drive Plate Removal and Installation (CVT)
- EVAP Canister Filter Removal and Installation(2WD)
- Engine Assembly Torque Rod Removal and Installation
- Engine Oil Pan Removal and Installation
- Engine Oil Pump Removal and Installation
- Engine Removal and Installation
- FTP Sensor Removal and Installation (KA/KC)
- Injector Removal and Installation
- Intake Air Resonator Removal and Installation
- Knock Sensor Removal and Installation
- PCM Removal and Installation
- Piston, Ring, Pin, and Connecting Rod Removal and Installation
- Pulley End Crankshaft Oil Seal Replacement - In Car
- Rocker Arm Assembly Removal and Installation
- Throttle Body Removal and Installation
- Transmission End Crankshaft Oil Seal Replacement - In Car
- Valve Guide Replacement
- Valve, Spring, and Valve Seal Removal and Installation
READ NEXT:
A/F Sensor Removal and Installation
Special Tools Required
O2 Sensor
Wrench Snap-on
S6176 or
equivalent,
commercially
available
Removal & Installation
1. A/F Sensor - Remove
Fig. 1: A/F Sensor With Torque Specification
Disconnec
Air Cleaner Element Removal, Installation, and Inspection
Removal & Installation
1. Air Cleaner Element - Remove
Removal & Installation
Air Cleaner Element - Remove
2. All Removed Parts - Install
Install the parts in the reverse order of remov
CKP Sensor Removal and Installation
Removal & Installation
1. Engine Undercover (2WD) - Remove
2. CKP Sensor Cover - Remove
Remove the CKP sensor cover (A).
3. CKP Sensor - Remove
4. All Removed Parts - Install
Install the pa
SEE MORE:
Keyless/Power Door Locks/Security System Symptom Troubleshooting - Security
Alarm System Will Not Arm
NOTE: Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated,
troubleshoot the indicated
DTC first.
1. Switch information check:
Turn the vehicle to the ON mode.
Check the parameter(s) below with the HDS.
Is each switch information OK?
YES
Intermittent failure, the system is OK
DTC Troubleshooting B00D5-14: Open or Short to Ground in the Front
Passenger's Airbag Cutoff Indicator (KA/KC)
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
© 2019-2026 Copyright www.hohrv2.com
